HP ProDesk 600 G4 Base Model Small Form Factor PC Manual de usuario Pagina 75
- Pagina / 124
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Computer seems to be locked up.
Cause Solution
Program in use has stopped responding to commands. 1. Use the task manager to close programs that do not respond.
2. Attempt the normal Windows “Shut Down” procedure. If this
fails, press the power button for four or more seconds to turn
o the power. To restart the computer, press the power
button again.
Solving media card reader problems
Media card will not work in a digital camera after formatting it in Windows.
Cause Solution
By default, Windows will format any media card with a capacity
greater than 32MB with the FAT32 format. Some digital cameras
use the FAT (FAT16 & FAT12) format and can not operate with a
FAT32 formatted card.
Either format the media card in the digital camera or select FAT le
system to format the media card in a computer with Windows.
A write-protected or locked error occurs when attempting to write to the media card.
Cause Solution
Media card is locked. Locking the media card is a safety feature that
prevents writing to and deleting from an SD/Memory Stick/PRO
card.
If using an SD card, make sure that the lock tab located on the right
of the SD card is not in the locked position. If using a Memory
Stick/PRO card, make sure that the lock tab located on the bottom
of the Memory Stick/PRO card is not in the locked position.
Can not write to the media card.
Cause Solution
The media card is a read-only memory (ROM) card. Check the manufacturer’s documentation included with your card to
see if it writable. Refer to the previous section for a list of
compatible cards.
Media card is locked. Locking the media card is a safety feature that
prevents writing to and deleting from an SD/Memory Stick/PRO
card.
If using an SD card, make sure that the lock tab located on the right
of the SD card is not in the locked position. If using a Memory
Stick/PRO card, make sure that the lock tab located on the bottom
of the Memory Stick/PRO card is not in the locked position.
Unable to access data on the media card after inserting it into a slot.
Cause Solution
The media card is not inserted properly, is inserted in the wrong
slot, or is not supported.
Ensure that the card is inserted properly with the gold contact on
the correct side. The green LED will light if inserted properly.
Solving media card reader problems 67
- Maintenance and Service Guide 1
- About This Book 3
- Table of contents 5
- 1 Product features 9
- Front panel components 10
- Rear panel components 11
- 2 Illustrated parts catalog 12
- Computer major components 5 13
- Miscellaneous parts 14
- Miscellaneous parts 7 15
- Miscellaneous parts 9 17
- Miscellaneous parts 11 19
- Miscellaneous parts 13 21
- Miscellaneous parts 15 23
- Miscellaneous parts 17 25
- Miscellaneous parts 19 27
- Miscellaneous parts 21 29
- Generating static 30
- Grounding the work area 31
- Operating guidelines 32
- Routine care 33
- Service considerations 34
- SMART ATA drives 35
- Preparation for disassembly 36
- Access panel 37
- Optical drive 38
- Front bezel 39
- Hard drives 40
- Drive cage 42
- Memory module 43
- Power supply 45
- Fan shroud 46
- Fan-sink 47
- Processor 48
- Serial connector module 50
- System board 51
- 6. Remove the lower cage (2) 52
- System board 45 53
- Connector board 54
- Computer Setup–Main 57
- Computer Setup—Security 59
- Computer Setup—Advanced 61
- Safety and comfort 67
- Helpful hints 68
- Solving general problems 69
- Solving general problems 63 71
- Solving power problems 72
- Solving hard drive problems 73
- Solving display problems 76
- Solving display problems 69 77
- Solving display problems 71 79
- Solving audio problems 80
- Solving audio problems 73 81
- Solving printer problems 82
- Solving network problems 86
- Solving network problems 79 87
- Solving memory problems 89
- Solving software problems 92
- 10 System backup and recovery 106
- Using Windows tools 108
- Restore and recovery 108
- A Battery replacement 111
- Current BIOS steps 114
- Nonvolatile memory usage 116
- Nonvolatile memory usage 109 117
- Questions and answers 118
- Using HP Sure Start 119
- C Power cord set requirements 120
- Country-specic requirements 121
- D Specications 122
Relacionado con productos y manuales para No HP ProDesk 600 G4 Base Model Small Form Factor PC
No HP AMP 130 Printer Manual de usuario
(132 paginas)
(132 paginas)
(84 paginas)
(89 paginas)
No HP ProDesk 400 G3 Microtower PC Manual de usuario
(48 paginas)
(48 paginas)
(48 paginas)
(40 paginas)
No HP Ink Tank 310 Manual de usuario
(99 paginas)
(99 paginas)
No HP EliteDesk 800 G4 Tower PC Manual de usuario
(76 paginas)
(76 paginas)
No HP Tango Manual de usuario
(106 paginas)
(106 paginas)
No HP OMEN - 15-dc0086nr Manual de usuario
(80 paginas)
(69 paginas)
No HP ZBook 17 G2 Mobile Workstation Manual de usuario
(126 paginas)
No HP ENVY 5534 e-All-in-One Printer Manual de usuario
(110 paginas)
(110 paginas)
No HP OMEN Keyboard 1100 Manual de usuario
(11 paginas)
(11 paginas)
(70 paginas)
No HP ENVY 5010 All-in-One Printer Manual de usuario
(109 paginas)
(109 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.227 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales