HP ProDesk 600 G4 Base Model Small Form Factor PC Manual de usuario descargar pdf (Pagina 45)

Power supply

Follow these steps to remove the power supply:

1. Prepare the computer for disassembly (see Preparation for disassembly on page 28).

2. Remove the access panel (see Access panel on page 29).

3. Remove the front bezel (see Front bezel on page 31).

4. Remove the drive cage (see Drive cage on page 34).

Remove the power supply:

1. Position the computer with the rear panel toward you.

2. Disconnect the power supply P1 (1), P2 (2), and P3 (3) cables from the system board.

3. Release the power supply P3 cable from the retention clips built into the fan shroud (4).

4. Remove the four Torx-15 M3.0×9.0 screws (5) that secure the power supply to the computer chassis.

5. Press down on the power supply release tab (6).

6. Slide the power supply forward, and then remove the power supply (7).

Reverse this procedure to install the power supply.

Power supply 37

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 123 124

Sin comentarios

HP ProDesk 600 G4 Base Model Small Form Factor PC Manual de usuario Pagina 45