HP ProDesk 600 G4 Base Model Small Form Factor PC Manual de usuario descargar pdf (Pagina 47)

Fan-sink

NOTE: The fan-sink spare park kit includes replacement thermal material.

Follow these steps to remove the fan-sink:

1. Prepare the computer for disassembly (see Preparation for disassembly on page 28).

2. Remove the access panel (see Access panel on page 29), and then remove the following components:

a. Front bezel (see Front bezel on page 31)

b. Drive cage (see Drive cage on page 34)

c. Shroud (see Fan shroud on page 38)

Remove the fan-sink:

1. Disconnect the fan-sink cable (1) from the system board.

2. Loosen the four slotted Torx-15 captive screws (2) that secure the fan-sink to the computer chassis.

NOTE: Due to the adhesive nature of the thermal material located between the fan-sink and

the processor, it may be necessary to move the fan-sink from side to side when removing the it.

3. Remove the fan-sink (3).

Reverse this procedure to install the fan-sink.

Fan-sink 39

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 123 124

Sin comentarios

HP ProDesk 600 G4 Base Model Small Form Factor PC Manual de usuario Pagina 47