HP 8800 Router Series Manual de instalación descargar pdf (Pagina 21)

3. Remove the blank panel (if any) from the slot to be used on the SPE card.

4. Unpack the subcard.

To install a subcard:

1. Turn the ejector levers of the subcard outward simultaneously with both hands, and then slide

the subcard (with the right side up) straight into the SPE card along the slide rails until the

ejector levers touch the panel of the SPE card, as shown in Figure 15.

2. Push against the front panel of the subcard. When the front panel is close enough to the SPE

card, pivot the ejector levers of the subcard inward with both hands so that the front panel is

flush with the panel of the SPE card.

3. Use a Phillips screwdriver to fasten the mounting screws on the subcard.

Figure 15 Installing a subcard

Connecting power cables

Check the following items before connecting power cables:

• For lightning protection, the AC power should be routed through an external lightning device

into the router. For more information, see "Lightning protection."

• The power switch on the power supply is in the OFF position.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 120 121

Sin comentarios

HP 8800 Router Series Manual de instalación Pagina 21