HP 8800 Router Series Manual de instalación descargar pdf (Pagina 54)

Figure 30 Replacing a DC power supply

(

) DC power supply to be removed (B) DC power supply to be installed

Replacing an AC power supply

1. Pull the handle of the power supply downward to the unlock position. Gently move the power

supply to separate it from the backplane of the power frame.

2. Supporting the bottom of the power supply with one hand and holding the power supply

handle with the other hand, gently pull the power supply out.

Put the removed power supply on an antistatic mat or into the original shipping materials.

NOTE:

If the power frame is installed with two AC power supplies, repeat steps 1 and 2 to remove the other

power supply.

3. Use a Phillips screwdriver to loosen the captive screws on both sides of the power frame.

4. Supporting the bottom of the power frame with one hand and holding the power frame handle

with the other hand, gently pull the AC power frame out along the slide rails.

Place a removed power frame in an antistatic bag or its original shipping materials.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 120 121

Sin comentarios

HP 8800 Router Series Manual de instalación Pagina 54