HP 8800 Router Series Manual de instalación descargar pdf (Pagina 23)

ARNING!

To protect operators from being shocked, install the protection cover over the DC terminal block

immediately after you connect the power cables.

To connect the DC power cables:

1. Remove the protection cover of the DC terminal block from the DC power supply.

2. Loosen the fastening screws on the top two terminals with a Phillips screwdriver.

3. Connect one end of the blue –48 VDC power cable to the negative terminal (–) on the power

supply and fasten the screw. Connect the other end of the cable to the negative –48 V terminal

(–) on the power source.

The –48 VDC cable is marked with a minus sign (–).

4. Connect one end of the black DC power cable to the RTN (+) terminal on the power supply and

fasten the screw. Connect the other end of the cable to the RTN (+) terminal on the power

source.

The black DC power cable is marked with a plus (+) sign.

5. Put the protection cover over the DC terminal block.

Figure 17 Connecting DC power cables

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 120 121

Sin comentarios

HP 8800 Router Series Manual de instalación Pagina 23