HP 8800 Router Series Manual de instalación descargar pdf (Pagina 57)

2. Remove the blank panel (if any) from the slot to be used. Keep the removed blank panel and

protection cover for future use.

3. Unpack the card to be installed. If the card has a protection cover, remove it. Keep the

removed protection cover for future use.

Figure 34 Removing the protection cover

To replace a card:

1. Put on an ESD-preventive wrist strap and loosen the captive screws on both sides of the card to

be removed.

2. Pull the ejector levers outward to separate the card from the backplane of the chassis.

3. Slowly pull out the card along the slide rails. Put the removed card on an antistatic mat or into

its original shipping materials.

4. Pivot the ejector levers outward. Supporting the card with both hands, gently insert the card into

the slot along the slide rails.

5. Push the ejector levers inward to ensure close contact between the card and the backplane.

6. Position the screws in the holes and fasten them with a screwdriver.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 120 121

Sin comentarios

HP 8800 Router Series Manual de instalación Pagina 57