HP 8800 Router Series Manual de instalación descargar pdf (Pagina 46)

Field Remarks

XFP

RX loss of signal RX signal is lost.

RX not ready RX is not ready.

RX CDR loss of lock RX clock cannot be recovered.

TX fault TX fault.

TX not ready TX is not ready.

TX CDR loss of lock TX clock cannot be recovered.

Module not ready Module is not ready.

APD supply fault Avalanche Photo Diode (APD) supply fault.

TEC fault Thermoelectric Cooler (TEC) fault.

Wavelength unlocked

Wavelength of optical signal exceeds the manufacturer's

tolerance.

RX power high RX power is high.

RX power low RX power is low.

TX power high TX power is high.

TX power low TX power is low.

TX bias high TX bias current is high.

TX bias low TX bias current is low.

Temp high Temperature is high.

Temp low Temperature is low.

Voltage high Voltage is high.

Voltage low Voltage is low.

Transceiver info I/O error Transceiver information read and write error.

Transceiver info checksum error Transceiver information checksum error.

Transceiver type and port configuration

mismatch

Transceiver type does not match port configuration.

Transceiver type not supported by port

hardware

Transceiver type is not supported on the port.

# Display the currently measured values of the fault detection parameters for the transceiver module

plugged in interface GigabitEthernet 3/1/1.

<Sysname> display transceiver diagnosis interface Gigabitethernet 3/1/1

GigabitEthernet3/1/1 transceiver diagnostic information:

Current diagnostic parameters:

Temp(°C) Voltage(V) Bias(mA) RX power(dBM) TX power(dBM)

36 3.31 6.13 -35.64 -5.19

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 120 121

Sin comentarios

HP 8800 Router Series Manual de instalación Pagina 46