Hp StorageWorks DAT 72x10 Tape Autoloader Manual de usuario Pagina 24

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 62
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 23
Figure 8 Installing the rails into the rack (examp le shows an HP Rack10000 Series)
Description
Number
1
Usethe screws (x8) from thescrew pack foryourracktype.
To install the autoloader on the rails and into the rack:
1. Locate the captive screws on the front mounting brackets of the autoloader (see Figure 9).
2. Slide the back edge of the autoloader onto the rails. Push the autoloader back until the front bezel
is
ush with the front rack columns.
NOTE:
Thereshouldbenocablesconnectedtotheautoloaderatthispoint.
3. From the front of the autoloader, secure the front mounting brackets to the rack using a #2 Phillips
screw d river to tighten the captive screws on each side of the autoloader, as shown in Figure 9.
24
Installing the autoloader
Vista de pagina 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 61 62

Comentarios a estos manuales

Sin comentarios