Hp StorageWorks DAT 72x10 Tape Autoloader Manual de usuario descargar pdf (Pagina 57)

IMPORTANT:

You should not meet any resistance while removing the magazine. However, if there has

been a power failure, a cartridge may be not be fully seated in the magazine slot. If it feels

as if there is an obstruction, stop. Do not try to pull the magazine out by force; you may

damage the autoloader. Contact your HP support representative.

Figure 18 Releasing the magazine

Number

Description

Push a straightened paper clip into the access hole

Pull themagazineout of thefront of theunit

4. If there are additional car tridges still in the autoloader, or if you were unable to manually

remove the magazines and drive, contact HP ser vice for further instructions. See

“HP technical support” on page 10.

Inability to insert or remove a magazine (also error 8D)

It is possible that a tape is not fully inserted in the magazine but the magazine is still allowed to be

loaded in the autoloader. This tape could then come out further and obstruct the robot.

If the mag azine inserted was the lef t magazine

1. Power down the unit.

2. Remove the autoloader from the rack.

3. Tilt it so theleftsideofthe autoloader is facing up.

4. Gently rock the autoloader and listen for the sound of a cartridge coming out of the m agazine and

rattling around. If there is no loose cartridge sound, set the autoloader down and contact you

local service representative.

5. If there is a rattling sound, tilt the autoloader so that the front right corner is the lowest point and then

gently set the autoloader down on a horizontal surface

6. Manually release and remove the right magazine.

7. The cartridge should be visible in the o pening for the right magazine. Reach in and pull it out.

8. Replace the right magazine.

9. Manually remove the left magazine.

DAT 72x10 1U Tape Autoloader

1 2 ... 52 53 54 55 56 57 58 59 60 61 62

Sin comentarios

Hp StorageWorks DAT 72x10 Tape Autoloader Manual de usuario Pagina 57