Hp StorageWorks DAT 72x10 Tape Autoloader Manual de usuario descargar pdf (Pagina 59)

MM: month

dd: days

hh: hours

mm: minutes

NOTE:

Thetimestampusesa24-hourclock,where13:00=1p.m.

Summary of M ain Error codes

The following table provides general guidelines about main error codes and steps that you ca n take to

remedy the problem. Using the above example, you would look up 8C in the table to see what action

you could take. The table does not include any information about suberror codes, as this is mainly

relevant for service engineers.

A more complete description of each error code a n d possible solution is provided in a separate document

(English only) , which can be found on the HP StorageWorks CD-ROM supplied with the product or the HP

web site, w

ww.hp.com. This document also contains the suberror codes.

Table 12 Main Error codes

Error Codes

Description

Solution

82,83, 84, 85,86, 87,88

Parameter settings have failed on

one

of the robotic components

• Power cycle the unit and retry.

89, 8A, 8B, 8C, 8D,8E, 8F,90,

91,

92, 93, 94, 95, 96, 97, 98,

99,9A, 9B,9C, 9D,9E, 9F, A0

There is a problem with one of the

robotic components, such as an

obstruction or unexpected range

of movement

• Run the Wellness Test from the

Support menu.

B0, B1, B2

There is a communication error

between the library controller and

the

robotic controller

• Reset the unit and retry the

operation.

Robot stopped due to a released

magazine

• Check if the magazine is

completely inserted and retry

the

operation.

"Tape in gripper" sensor did not

report the expected value.

• Remove and inspect the

magazine involved for a stuck

tape.

•

Run the Wellness Test from the

Support menu.

There is a communication error

between the library controller and

the

robotic controller

• Reset the unit and retry the

operation.

There is a ROM checksum error

during ﬁrmware upgrade

• Cycle power on the autoloader

and attempt the operation

again.

D1, D2, D3, D4, D5, D6, D7, D8

Thereisa system,clock,display

memory error

• Cycle power on the autoloader

and attempt the operation

again.

There is an error on the drive fan,

fanmotionhas stopped

The autoloader reports on the

status of the external fan for the

drive; it does not check the fan for

the

power supply.

•

Check that the drive fan is

operational and not obstructed.

DAT 72x10 1U Tape Autoloader

1 2 ... 54 55 56 57 58 59 60 61 62

Comentarios a estos manuales

Sin comentarios

Hp StorageWorks DAT 72x10 Tape Autoloader Manual de usuario Pagina 59

Comentarios a estos manuales

Relacionado con productos y manuales para Almacenamiento Hp StorageWorks DAT 72x10 Tape Autoloader