Hp StorageWorks DAT 72x10 Tape Autoloader Manual de usuario descargar pdf (Pagina 25)

Number

Description

Slide the back edge of the autoloader onto the rails. Push until the front bezel is ﬂush

with the rack columns.

Tighten the captive screws on the front brackets of the autoloader.

Figure 9 Securing the autoloader to the rack

Connecting the SCSI and power cord

NOTE:

The DAT 72x10 Tape Autoloader tape drive is an Ultra160 SCSI LVD/SE device. Only cables and

terminato

speciﬁed for Ultra160 use or labeled as Multimode should be used.

WARNING!

This product can ONLY be used with an HP approved power cord for your speciﬁcgeographicregion.

Use of a non-HP approved power cord may result in : 1) not meeting individual country speciﬁcsafety

requirements; 2) insufﬁcient conductor ampacity that could result in overheating with potential personal

injury a nd /or property damage; and 3) an unapproved power cord c ould fracture resulting in the

internal contacts being exposed, which potentially could subject the user to a shock hazard. HP disclaims

all

liability in the event a non-HP approved power cord is used.

To connect the SCSI and power cord to the autoloader:

CAUTION:

Failure to remove the power cords from these devices could result in damage to the autoloader.

1. Shut down and turn off the selected server. Turn off a ll attached devices, such as printers and other

SCSI devices. Remove the p ower cords from the server and all attached accessories.

2. Attach one end of the SCSI cable (included in the accessory package) to one of the connectors on

the

back panel of the autoloader (see Figure 10).

DAT 72x10 1U Tape Autoloader

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 61 62

Sin comentarios

Hp StorageWorks DAT 72x10 Tape Autoloader Manual de usuario Pagina 25