
28 Disk Enclosure Components
Figure 4
Disk Module
Disks fit snugly in their slots. The cam latch (B in Figure 4) is used to seat and unseat the
connectors on the backplane.
A label (G) on the disk provides the following information:
•
Disk mechanism height: 1.6 inch (half height) or 1 inch (low profile)
•
Rotational speed: 10K RPM and 15K RPM (18 Gbyte only)
•
Capacity: 9.1 Gbyte, 18.2 Gbyte, 36.4 Gbyte, or 73.4 Gbyte
A large zero on the capacity label distinguishes a filler from a disk. Fillers are required in all
unused slots to maintain proper airflow within the enclosure.
C
AUTION
Fillers must be installed in unused slots to maintain proper cooling within
the disk enclosure.
A bezel handle
B cam latch E circuit board
C carrier frame F insertion guide
D standoffs G capacity label
Comentarios a estos manuales