Hp Surestore Disk Array 12h and FC60 Manual de usuario Pagina 389

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 466
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 388
Disk Enclosure Modules 389
Removal and
Replacement
Note
If the disk module you are installing has been removed from another Disk Array
FC60, you should ensure that the module has a status of Unassigned. This is
done by unbinding the LUN the disk module was a part of in the original disk
array. See "Moving Disks from One Disk Array to Another" on page 255.
1. Remove the replacement disk from its ESD bag, being careful to grasp the disk by its
handle (A in Figure 96).
2. Pull the cam latch (B) away from the disk module.
3. Mark the slot number that the disk is being installed into on the Slot Location Map on
the top of the disk module. See Figure 95. This facilitates reinstalling the disk module in
the correct slot.
Figure 95
Disk Slot Identification Label
Note
Use both hands to hold the disk — one on the handle and the other on the
carrier frame.
4. Slide the disk module into the slot with capacity label up (C in Figure 96).
Mark Slot
Vista de pagina 388
1 2 ... 384 385 386 387 388 389 390 391 392 393 394 ... 465 466

Comentarios a estos manuales

Sin comentarios