Hp Surestore Disk Array 12h and FC60 Manual de usuario Pagina 400

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 466
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 399
400 Controller Enclosure Modules
Battery Backup Unit (BBU) Removal/Replacement
!
Hot Swappable Component!
Note
If the Fast Write Cache LED is on when the BBU is removed from the enclosure
(or if the BBU fails), write caching will be disabled and the write cache data will
be written to disk. However, if a power outage occurs prior to completing the
cache write to disk, data may be lost. Therefore, make sure the Fast Write
Cache LED is off before replacing the BBU.
Removing the BBU
1. Remove the controller enclosure front cover. See "Front Cover Removal/Replacement"
on page 397.
2. Loosen the four screws (two on each side) on the BBU. See Figure 101.
C
AUTION
The BBU weighs approximately 24 pounds so be prepared to support its
weight when you pull it out of the chassis. The BBU is not as deep as other
modules and disengages the enclosure sooner than you may expect.
3. Grasp the two handles and slide the module out about two inches.
4. Grasp both sides of the module with both hands and slide it out of the enclosure.
Vista de pagina 399
1 2 ... 395 396 397 398 399 400 401 402 403 404 405 ... 465 466

Comentarios a estos manuales

Sin comentarios