HP Integrity NonStop H-Series Guía de usuario descargar pdf (Pagina 108)

HP NonStop Shadowbase Command Definitions

Collector Command Descriptions

HP NonStop Shadowbase Command Reference Manual—785421-002

DOC ROLL STATUS INFO (PREVIOUS) – This section is only displayed

after the first DOC roll completes.

SCHEDULE shows the scheduled time of the last completed roll preceded by

the type of roll schedule used:

ADT – Audit trail based.

TOD – Time of day based.

CMD – User command based.

LAST AUDITTRAIL REC shows the timestamp of the last audit trail record

processed before the DOC roll began. If no audit trail records were

processed, “NONE READ” will appear.

START shows the time the DOC roll started.

STOP shows the time the DOC roll completed.

DUR shows the time the DOC roll took, in minutes.

MIN shows the minimum DOC roll duration since HP Shadowbase started.

MAX shows the maximum DOC roll duration since HP Shadowbase started.

QMGR AND CONSUMER MESSAGE PENDING INFO – This section

displays information relating the outstanding messages to the Consumer.

This section is only displayed when specifying ,DETAIL in the STATS

COLL command.

CONSNAME shows the Consumer or Queue Manager object name associated

with the STATS.

TRANS BUSY shows the number of active transactions assocated with object.

MSG QUEUE

MSG BUSY

ETS LAG

LTS LAG

QMGR AND CONSUMER MESSAGE RESPONSE INFO – This section

displays information relating to messages acknowledged by the

Consumer. This section is only displayed when specifying ,DETAIL

in the STATS COLL command.

CONSNAME shows the Consumer or Queue Manager object name associated

with the STATS.

BYTES SENT shows the total number of inter-process message bytes sent to

the related CONS or QMGR for the reported duration.

NUM WRTRDS shows the number of messages sent and responded to

(i.e.,i.e., the ACK was received) by the related CONS or QMGR for the

reported duration.

WRTRD TIME shows the total time spent for message handling for the

reported duration (from the writeread until immediately after the CONS’s

or QMGR’s ACK response is received).

AVG RESP shows the average message response time for the reported

duration computed by dividing the NUM WRTRDS into the WRTRD TIME.

RLQ shows “Y” if the CONS RESOLVELOCKSQ parameter is set to ON.

Otherwise, it shows “N”. Note that when RESOLVELOCKSQ is ON, a

CONS reply message does not indicate that it has been processed end-to-

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 345 346

Comentarios a estos manuales

Sin comentarios

HP Integrity NonStop H-Series Guía de usuario Pagina 108

Comentarios a estos manuales

Relacionado con productos y manuales para Software HP Integrity NonStop H-Series