HP Integrity NonStop H-Series Guía de usuario descargar pdf (Pagina 152)

HP NonStop Shadowbase Command Definitions

Consumer Command Descriptions

HP NonStop Shadowbase Command Reference Manual—785421-002

143

object is configured to set the NETBACKUPPROCESS,

NETBACKUPADDRESS, and NETBACKUPPORT parameters.

Once a listen has been posted, an STP server will wait for a connection

for NETLISTENTIMEOUT period of time and then re-cycle the “listen” on

that path (i.e.,i.e., it will tear down the current socket(s) and re-establish

another listen to the primary and/or backup path if defined).

If an STP server is able to establish a listen on one path, but is unable to

“listen” for a connection on the other path (i.e.,i.e., an error occurs trying to

establish the “listen”), it will retry a “listen” every NETRETRYDELAY

period of time until either a connection is established on the successful

path or a NETLISTENTIMEOUT condition occurs. Note that the next set

of “listens” will be posted after NETRETRYDELAY time lapses.

NETMAXERRORS num

Initial Changed

Version Version Values Default Minimum Maximum Alter

2.500 1 0 indefinite 128 No

Client Server Extended Open Target

The maximum number of communication failures to be tolerated in a

TCP/IP replication environment before the Consumer. Valid values are 0

through 128. The default value is 1. When set to 0, the connection will be

retried indefinitely. Setting NETMAXERRORS to 1 means the automatic

recovery is disabled and the Consumer abends as soon as the first

communication fault is detected. When the value is set greater than 1,

NETMAXERRORS defines the number of failures tolerated within the

value defined by NETERRORSPAN.

Note: NETMAXERRORS must be 1 for replicating to HP Shadowbase

Other Servers environments that write to a DOC or when an HP

Shadowbase Other Servers is configured with multiple ports. If

your open target is a DOC, this value must be set to 1. If it is set

greater than 1, a NAK_NETMAXERRORS (16) is reported in

AUDCOM at start up. In these situations, use the AUDMON

AUTORESTART parameter to achieve automatic recovery.

NETPORT num

Initial Changed

Version Version Values Default Minimum Maximum Alter

1.100 None 1 65535 No

Client Server Extended Open Target

This identifies the port on the NETADDRESS to use for the TCP/IP

socket. There is no default value. The minimum value is 1 and the

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 345 346

Comentarios a estos manuales

Sin comentarios

HP Integrity NonStop H-Series Guía de usuario Pagina 152

Comentarios a estos manuales

Relacionado con productos y manuales para Software HP Integrity NonStop H-Series