HP Integrity NonStop H-Series Guía de usuario descargar pdf (Pagina 11)

HP NonStop Shadowbase Command Reference Manual—785421-002

Introduction

Overview

This manual provides the detail definitions for all commands used to

configure, operate, and manage HP Shadowbase. Command definitions

are categorized as described in the next section.

AUDCOM Command Punctuation

An AUDCOM command line spans input records if the last non-blank

character is an ampersand (&). Multiple commands, separated by

semicolons, can appear on the same line. For example,

command-1; command-2; command-3; command-4; &

command-5; command-6...

Comments can be used to document AUDCOM commands. Comments

can be embedded within a command or can appear on separate lines.

Comments must be enclosed in brackets ( []) if they are embedded

within an AUDCOM command. If the comments appear at the end of an

AUDCOM command or on a line by themselves, the comment only needs

the left bracket to be recognized. No other comment character is

permitted. For example the following lines all perform the “STATUS AUD”

command.

STATUS [this is a comment] AUD

STATUS AUD [this is a comment at the end of a command

STATUS AUD

AUDCOM Command Categories

AUDCOM commands are grouped into five logical categories. These

categories are:

Basic commands

Commands used to set context within an AUDCOM session and remain in

effect for the duration of the AUDCOM session.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 345 346

Sin comentarios

HP Integrity NonStop H-Series Guía de usuario Pagina 11