HP Integrity NonStop H-Series Guía de usuario Pagina 75

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 346
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 74
HP NonStop Shadowbase Command Definitions
Collector Command Descriptions
HP NonStop Shadowbase Command Reference Manual—785421-002
66
this audit trail first. If the ADTSTARTTIME indicated is lower than the
earliest time in the first audit trail read, the Collector will search the TM/MP
catalog for the audit trails that contain the desired time. This is an optional
parameter. This parameter cannot be used to position the collector for
starting in a bi-directional replication environment.
Notes: This parameter will be ignored upon HP Shadowbase startup
if the file indicated by the RESTARTFILE parameter exists.
Note: This parameter will be ignored if the parameter ADTSTARTEOF is
set to ON.
ADTSTARTTIME uses the TMF master (MAT) audit trail time stamps for
positing. On systems configured to use master (MAT) and auxiliary (AUX)
audit trail files, the specified date and time values are significant only for
the master audit trail. The TMF subsystem stores event data in the AUX
file(s) and stores a pointer record in the MAT file following the successful
AUX write(s). For example, there can be events in the AUX file that are
timestamped between 07:30:01 and 07:30:59 , but the related AUX
Pointer record in the MAT file may not have been written until 07:33:01.
When this situation is the case and you set your starting ADTSTARTTIME
to 07:32:00, these events will be processed (assuming other HP
Shadowbase parameters, such as the ADTAUXMASK, do not filter off
these events). Similarly, if you set the ADTSTARTTIME to 07:29:00 and
the ADTSTOPTIME to 07:32:00, these AUX events will not be processed
even though they occurred during this interval (because their AUX pointer
record does not occur within this interval).
ADTSTOPEOF { ON }
{ OFF }
Initial Changed
Version Version Values Default Minimum Maximum Alter
2.000 OFF OFF ON Yes
When set to ON, this specifies that the Collector is to stop processing the
audit trail files when end-of-file is detected in the last file established by
the ADTSTOPNAME or ADTSTOPSEQHI Collector parameters. When
ON and ADTSTOPNAME and ADTSTOPSEQHI are not be specified,
audit trail reading terminates at the first end of audit trail condition
encountered on the audit trail currently being read. The default for this
parameter is OFF.
ADTSTOPNAME { adt_filename }
{ -1 }
Vista de pagina 74
1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 345 346

Comentarios a estos manuales

Sin comentarios