HP Integrity NonStop H-Series Guía de usuario descargar pdf (Pagina 150)

HP NonStop Shadowbase Command Definitions

Consumer Command Descriptions

HP NonStop Shadowbase Command Reference Manual—785421-002

141

asynchronous communication and the Consumer will continue to send

messages to the target process up to the NETBUFFERS value even if

acknowledgements are outstanding. If you set NETBUFFERS greater

than 1, it is recommended that you set the Collector parameter,

MAXCONSWRITES, to a similar value.

When replicating over TCP/IP to a cached target, it is recommended that

NETBUFFERS be set to 2x MAXCONSWRITES. For replication to a non-

cached target, the recommended setting is 4x MAXCONSWRITES.

NETCOMPRESS { ON }

{ OFF }

Initial Changed

Version Version Values Default Minimum Maximum Alter

3.910 OFF OFF ON No

Client Server Extended Open Target

Enables or disables compression. Valid values are ON or OFF. Any

combination of NETCOMPRESS and NETENCRYPT can be used. For

performance reasons, it is recommended that if NETENCRYPT is ON that

NETCOMPRESS be set ON also. The Consumer compresses the

message content first and then encrypts the compressed content.

NETCONNTIMEOUT num

Initial Changed

Version Version Values Default Minimum Maximum Alter

3.961 180 1 32767 Yes

Client Server Extended Open Target

This parameter is used as the timeout value during an STP client connects

to a non-DOC-writing STP server instead of NETTIMEOUT.

NETCONNTIMEOUT would typically be set lower than NETTIMEOUT.

NETCONNTIMEOUT allows a Consumer to detect connection problems

quicker than that previously allowed with NETTIMEOUT, since it is

necessary to set NETTIMEOUT greater than the time it takes to process

the audit trail events in a single STP message. The default for

NETCONNTIMEOUT is 180 seconds. The valid range is 1 through 32767

seconds.

Note: That DOCPREPTIMEOUT is used for connecting to DOC-writing

STP servers.

NETENCRYPT { ON }

{ OFF }

Initial Changed

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 345 346

Sin comentarios

HP Integrity NonStop H-Series Guía de usuario Pagina 150