HP Integrity NonStop H-Series Guía de usuario descargar pdf (Pagina 28)

HP NonStop Shadowbase Command Definitions

Monitor Command Descriptions

HP NonStop Shadowbase Command Reference Manual—785421-002

LOG Command

The LOG command specifies the name of an optional file used for

reporting changes in status. The syntax is:

LOG [ filename ]

filename

Is the name of a file to receive reports. When specifying a disk file, the file

must be an existing unstructured file. See the HP NonStop Shadowbase

Installation and Planning Manual for information on pre-creating the log

file. The filename can be fully qualified with volume and subvolume

names. The filename can also be $VHS. If omitted, the AUDMON home

terminal is used for logging. Entering LOG without a filename will close

the current log file.

If a LOG file is not available, AUDMON reports an error to the Event

Management System (EMS) Collector process $0.

OBEYFORM AUD Command

The OBEYFORM AUD command displays the parameter values in the

SET command format for the AUD object. The syntax is:

OBEYFORM [/OUT <listfile>/] { [AUD] }

listfile

is the name of a file to receive the output. listfile can be an edit file that

can subsequently be edited for use.

Note: Parameters that do not have values set are commented out.

An example of the results of doing an OBEYFORM AUD command is

shown below:

+obeyform aud

[BEGIN OBEYFORM OUTPUT AT 2014-08-13:15:17:10]

[SHADOWBASE VERSION INFO - V5010FH06 - (13MAY14)]

[AUD OBJECT SETTINGS (AUDMON \H2.$CJCMS):]

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 345 346

Sin comentarios

HP Integrity NonStop H-Series Guía de usuario Pagina 28