HP 7000 dl Router Series Guía de usuario descargar pdf (Pagina 782)

Command Reference Guide Tunnel Configuration Command Set

Use the bandwidth command to provide the bandwidth value of an interface to the higher-level protocols.

This value is used in cost calculations. Use the no form of this command to restore the default values.

Syntax Description

<value> Specifies bandwidth in kbps.

Default Values

To view default values, use the show interfaces command.

Command Modes

(config-interface)# Interface Configuration Mode

Valid interfaces include: Ethernet (eth 0/1), PPP virtual interfaces (ppp 1), HDLC

virtual interfaces (hdlc 1), Frame Relay virtual sub-interfaces (fr 1.20), tunnel

interfaces (tunnel 1), and VLAN interface (vlan 1).

Functional Notes

The bandwidth command is an informational value that is communicated to the higher-level protocols to

be used in cost calculations. This is a routing parameter only and does not affect the physical interface.

Usage Examples

The following example sets bandwidth of the tunnel 1 interface to 10 Mbps:

(config)#interface tunnel 1

(config-tunnel 1)#bandwidth 10000

Sin comentarios

HP 7000 dl Router Series Guía de usuario Pagina 782