HP MFP Digital Sending Software 5.0 Manual de usuario descargar pdf (Pagina 22)

Internally, the DSS service is divided into several subcomponents and has dependencies. The below

figure shows this at a high level:

Figure 2-4 DSS Service Architecture

DSS-enabled device

DSS-enabled devices are the HP MFPs, Digital Senders, or ScanJet products that support DSS.

These devices allow end-users to make use of DSS functionality by scanning to the various

destination types, using the address book etc. For a complete list of supported devices, see

Supported devices on page 5.

The firmware in these devices has a component built-in which enables use of DSS functionality. In

Pre-FutureSmart products this is enabled through DSMP (Digital Sending Management Protocol). In

HP's FutureSmart products this component has been replaced by a WS-* (Web Services Star) based

interface.

Since all DSS features must be supported by the device firmware, DSS 5.0 has a minimum firmware

version requirement, which can be found here

Table 3-4 Device firmware requirements on page 28.

Over time, as new features become available in DSS, it might be necessary to update the device

firmware for compatibility. These changes will be documented in detail in the DSS release notes.

I.R.I.S. OCR engine

DSS uses I.R.I.S. OCR engine version 12 to provide Optical Character Recognition (OCR) and High

Compression PDF functionality. The engine features Intelligent High Quality Compression (iHQC)

technology™. The engine features Intelligent High Quality Compression (iHQC) technology™, and

the ability to create searchable PDF/A documents.

14 Chapter 2 Theory of operations ENWW

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 121 122

Sin comentarios

HP MFP Digital Sending Software 5.0 Manual de usuario Pagina 22