HP MFP Digital Sending Software 5.0 Manual de usuario descargar pdf (Pagina 42)

Like the Admin User, the Config User’s password ships as blank as a factory default. The password

can be set within the EWS in the same location as the Admin User’s password. These are set on the

Security Tab in the General Security section. Unlike the Admin user however, the Config user is

inactive if the password blank. This user is only activated when the password is configured within the

EWS. See the screenshot below.

The Config User has been added so that companies can change the Admin password, if their

company security policies require, without changing the Config User password. This means that DSS

can be given the Config User’s password, instead of the Admin password, and continue to operate

properly when the Admin password is changed.

Figure 3-1 DSS General Security screen

DSS configuration and use of FutureSmart device credentials

DSS stores a single set of device-specific credentials for each device, and is also capable of storing

one set of common credentials it can use for communication with FutureSmart devices. See

Set the

DSS common credentials on page 35 for instructions of how to set these credentials. If DSS tries to

use the common credentials with a device and they work, then those common credentials will be

copied to the device-specific credentials for that device. See

Figure 3-2 DSS common and device-

specific credentials flow on page 35 for the logic of how DSS uses the common credentials and

device-specific credentials when adding a FutureSmart device.

34 Chapter 3 Installation and configuration ENWW

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 121 122

Sin comentarios

HP MFP Digital Sending Software 5.0 Manual de usuario Pagina 42