HP MFP Digital Sending Software 5.0 Manual de usuario descargar pdf (Pagina 62)

Figure 3-24 Device Configuration tab

2. In the Device List, click to select the device you want to remove, and then click Remove Device.

The Remove Device dialog box appears.

Figure 3-25 Remove Device dialog box

3. Click Yes to remove DSS-enabled devices.

Device configuration

After adding a new device (or group of devices), use the following procedure to configure the Digital

Sending features for the device or group.

1. On the DSS server, open the Configuration Utility and click the Device Configuration tab.

2. Select a device from the Device List.

3. Click Configure Device. The dialog box that appears looks similar to the main Configuration

program interface. Use this interface to customize the specific Digital Sending settings for this

device.

NOTE: Use this interface to enable the Digital Sending features for the individual devices.

Even if a feature is enabled on the DSS configuration tabs, it is not available on the device until it

has been enabled in the Configure Device interface.

54 Chapter 3 Installation and configuration ENWW

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 121 122

Sin comentarios

HP MFP Digital Sending Software 5.0 Manual de usuario Pagina 62